Huawei OLT

MA5600T · MA5603T · MA5608T · MA5680T · MA5683T · MA5800-X2/X7/X15/X17 · EA5800. Log in to the OLT (telnet/SSH/console) as an administrator and run the commands below. Replace the example values.

1. Enter config mode

   enable
   config

2. SNMP read community (v2c) optional — automatic

   Pick a community that is hard to guess — not public.

   snmp-agent sys-info version v2c v3
   snmp-agent community read cipher myolt-ro-7Hq2
   # older MA56xx firmware without 'cipher':   snmp-agent community read myolt-ro-7Hq2

   If your OLT limits SNMP with an ACL (for example snmp-agent community read cipher X acl 2001), add your MikroTik's IP to that ACL:

   acl 2001
    rule permit source 192.168.88.1 0
    quit

3. Telnet user for MyOLT

   Create a separate user, so you can see in the OLT log what MyOLT did and remove it any time.

   terminal user name
     User Name(length<6,15>): myolt01
     User Password(length<6,15>): ********
     Confirm Password(length<6,15>): ********
     User profile name(<=15 chars)[root]: root
     User's Level:  1. Common User  2. Operator  3. Administrator:  2
     Permitted Reenter Number(0--4): 3
     User's Appended Info(<=30 chars): MyOLT panel

   Operator is enough for ONU work (authorize, reboot, VLAN, speed, TR-069). Choose Administrator if you also want MyOLT to create line / service / traffic profiles. Keep your other users (and SmartOLT's, if any) as they are — MyOLT does not touch them.

4. Telnet on and allowed from your MikroTik

   sysman service telnet enable
   # only if 'display sysman firewall' shows the telnet firewall is enabled:
   sysman ip-access telnet 192.168.88.1 192.168.88.1

5. Save

   quit
   save

6. Check

   display snmp-agent community read
   display terminal user name myolt01

   Then in your panel: OLTs → Add → IP 192.168.88.10 (real IP), model Detect automatically, telnet user myolt01 and its password, SNMP empty → Save.

Good to know

• Management IP: the OLT's management address (vlanif or the meth port) must be reachable from your MikroTik — try /ping 192.168.88.10 on the MikroTik.
• Port numbers: SNMP 161/UDP and telnet 23/TCP. If you changed them on the OLT, enter the same in the panel.
• Polling load: MyOLT reads status every minute and light every 15 minutes, in as few SNMP walks as possible. A full MA5683T with 1,500 ONUs takes about 20–40 s per round.
• Many OLTs: repeat the steps on each; one tunnel serves every OLT in the same network.
• TR-069: the panel's TR-069 page creates the ACS profile on the OLT for you and shows which line profiles need "TR069 management".

Next: connect your MikroTik →